Not sure where this should go, but I guess it’s the editors problem.
I want to be able to click on a bus route and edit it by clicking on the roadways to be included. I know it’s just a case of going round your route, clicking on the ways and adding the relations, but it’s still a pain. I’d like to be able to select a route, then for the exisitng route to light up for me, and to just click on and off sections of the route. And then for this route to be shown, this is very important.
I guess part of the problem is that they arent rendered normally, they are just attributes of the way objects. From what I understand you need a special rendering engine like OSMI to see the routes.
- is the above correct (I’m new, obviously)
- and if so, is there any discussion about moving forward to something a little bit more usable. It seems like we are nearly there, but may be it’s a lot harder than that.
there’s an invalidated request here
http://trac.openstreetmap.org/ticket/2857
when it says “already does it”, I take it that means the add relaton dialogue, not “click on route and get it drawn for you”. Even just to have that list of relation members temporarlily draw the route you are currently editing would be nice, you cant see what you’ve ended up with.