You are not logged in.

#1 2008-02-25 09:53:18

haha
Member
Registered: 2008-02-25
Posts: 3

Question for creating POI in JOSM

hi All,

I am new to JOSM and try to use this tool to create my first map, however there is an issue with create POI, is there any button to create POI like shopping center? I try with "Preset", however seems no effect...

And I tried using button "Draw Node A" in the left side, however, if I try to create more than 2 POI, it always create as a line (road)....

And it seems there are some different with the JOSM with the example screen, if you look at attached file "example.jpg" and "my.jpg", in "example.jpg", I find some buttons not appeared in my JOSM (my.jpg), any idea about this? Do I need to activate some setting???

example.jpg
20080225_98912f9433c6d420d8f37c9ynVTiBInZ.jpg

my.jpg
20080225_2e054498823bec9f520eKxgpuuuub4Om.jpg

Thanks

Last edited by haha (2008-02-25 09:54:02)

Offline

#2 2008-02-25 11:46:36

JRA
Member
Registered: 2007-12-17
Posts: 671

Re: Question for creating POI in JOSM

Hi,

All you need is to create a point with the Draw nodes A tool and the feed the tags for the point with Add tool in the Properties/Memberships section.
Draw nodes tool defaults to drawing a line if you insert many points in sequence.  Unselect your first point for example by hitting "u" from the keyboard, and you can draw the next POI.

Offline

#3 2008-02-25 14:31:06

haha
Member
Registered: 2008-02-25
Posts: 3

Re: Question for creating POI in JOSM

JRA wrote:

Hi,

All you need is to create a point with the Draw nodes A tool and the feed the tags for the point with Add tool in the Properties/Memberships section.
Draw nodes tool defaults to drawing a line if you insert many points in sequence.  Unselect your first point for example by hitting "u" from the keyboard, and you can draw the next POI.

Thanks a lot, using "u", I can draw the POI.

wink

Offline

Board footer

Powered by FluxBB