You are not logged in.

#1 2012-12-10 22:47:07

tweant
Member
Registered: 2012-06-27
Posts: 33

Doors & Steps

Hi
I am new to indoor  mapping and I'm a little but confused about how to draw and tag properly doors and steps.
I follow IndoorOSM scheme and it does not exactly say how to do it.
I have already mapped a building in my town (relation http://www.openstreetmap.org/browse/relation/2627424).
Can somebody explain my doors and steps tagging rules? Ty in advance

Another things which are not mentioned in scheme:
1. Should rooms stick to each other or not? When yes, should I make every room as a seperate relation or just duplicate ways and make polygons?

Last edited by tweant (2012-12-10 23:06:21)

Offline

#2 2013-01-22 19:00:43

Timmo
Member
Registered: 2012-11-16
Posts: 30

Re: Doors & Steps

Hi tweant,

A door is tagged like a building entrance: entrance=yes. Steps are tagged with highway=steps.
I cannot answer your third question, sorry!

Greets,
Tim

Offline

#3 2013-05-02 21:28:59

marek kleciak
Member
Registered: 2010-10-11
Posts: 8,417

Re: Doors & Steps

3rd question:
there are 2 movements:
A. every rooms are separate polygons
B. Rooms are relations, every way is only once.

I think, B is better, because You can add only once width=<value> and height=<value> as attributtes of the lines which are parts of relation. The result is the cleam 3D model.
In this cas You need only once the door as a point. Also the ways to the rooms are easy done - with the end on each door.

cheers,
Marek

Offline

Board footer

Powered by FluxBB